Skip to content
Cleaning Your uKeg

Cleaning Your uKeg

on
After Each Use
Remove cap and rinse with hot water
  • Turn off gas
  • Remove cap and rinse with warm water. (less than 120 degrees F).
Rinse uKeg
  • Rinse uKeg with warm water.
  • Repeat 2-3 times until clean.
Install cap and rinse through with water
  • Install cap.
  • Use remaining nitro gas to flow water through tap.
  • Close tap.
Discharge remaining nitro gas
  • Discharge remaining nitro gas by turning dial and venting.
  • Remove and recycle gas cartridge.
Allow to dry
  • Allow to dry by pouring out remaining water.
  • Store with cap off and tap open in dry place.
For a More Thorough Cleaning
Fill with warm water and cleaning tablet
  • Fill with warm water under 120 degress F and 1 cleaning tablet.
  • Cap and shake well.
  • Baking soda is a suitable substitute.
Install cap and rinse with water
  • Install cap, charge briefly with left-over nitro gas, flow water through tap and close tap.
  • Let sit 10 minutes.
  • Open tap until pressure runs out.
Remove nozzle for cleaning
  • Remove the nozzle for cleaning and drying.
  • Rinse (make sure parts inside nozel remain intact).

Related Posts

Cartridge Seal Replacement
August 25, 2023
Cartridge Seal Replacement

Learn how to replace your cartridge seal on the uKeg Cap. 

Read More
Brewing Nitro Cold Brew
August 25, 2023
Brewing Nitro Cold Brew

Info on how to brew your coffee in your uKeg Nitro.

Read More
Drawer Title
Similar Products